16-Channel Intelligent Laptop battery tester charger discharger
support 16pcs batteries at once 
test ,charge ,discharge,calibrate capacity,50% capacity

Feature:
1.Support 16-channel batteries at once
2.Supply for charge, discharge, test, capacity correction, charge/discharge 50% capacity function
3.Real-time updates batteries data,LED indicates working status.
4.Obtain detailed information each channel battery accurately, and intuitive display by software interface
5.Real-time draw record battery working curve

Basic Parameters
Size:540×315×220mm
Weight:15kg
Input: 100~240V,
Output: 24V/32A
Charge Current:2A/2.5A(Max)
Discharge Current:500m/3A(Max)
Standby Power Consumption:≤1W
Working Temperature:0-40℃,20%-90% RH(Non Condensing)
Storage Temperature:-20℃-65℃,10%-95% RH(Non Condensing)
Cooling: active cooling
Intelligent Protection: overvoltage, over-current protection, short circuit protection and exception alerts
Accessories:1*RFNC8 ,1*power cord ,8*2.0mm universal wire ,8*2.5mm universal wire

Function
1.Charge
Battery charge include following several stages,the initial battery charge mode depending on battery starting voltage , the charging process may not need to activate and pre-charge
2. Discharge
Internal constant current discharge,discharge current default is 500mA, up to 3A.You can set the discharge current through RFNC8 software ,may exist a little deviation between set value and actual value,specific value is unrelated with batteries.
3. Test
By charging and discharging the battery for short time,to test the charge/ discharge function is good or bad . Charge 20s, discharge 10s.
Test OK ,the LED green light flashing , and the software pop-up prompt.
Test Fail ,the LED red light flashing and the software pop-up prompt
4.Capacity Correction
The battery capacity value in the battery management chip will different from the actual capacity after a battery goes through many recycling cycles. It will affect the use of the battery when the difference reaches a certain degree. Capacity correction is to deep discharge a battery and then fully charge, which will correct the capacity value in the battery management chip.
5.CD50% & DC50%
CD50%: charge firstly, and then discharge to 50% capacity
DC50%: discharge firstly, and then charge to 50% capacity