Introduction :
Digital clamp meter integrated with AC / DC hall effect sensor, 3-3/4 Digit 6000 Count, True RMS, auto and manual measurement.

Advance features :
- Wide response band width.
- Large LCD display.
- Audible sound and visible indication during continuity check.
- Non-contact Frequency detection ‘NCF’ 50 / 60 Hz
- Software calibrated.

Specifications :
- True RMS
- 6000 counts (3-3/4 digit)
- Auto / Manual ‘V’ (600V AC)
- Auto / Manual ‘V’ (AC ) with Hz / % selectable
- Auto / manual resistor measurement (60MΩ)
- Continuity check : <50Ω Beep
- Diode check : 3.000 V
- 600A / 600A (AC / DC) current
- AC current with Hz / % selectable
- Capacitance : 10nF - 100mF
- Frequency 10Hz - 10MHz
- Hz / Duty cycle 1-99%
- ‘NCV’ Non-Contact AC Voltage Detection (Audible and Visible) > 100V : Numerical digital display AC voltage strength
- Freeze / Hold reading
- Auto power off : (5 mins)
- Anti Burn Protection (ABP) on full range and up to 250V (AC / DC) (NOT at μA / mA CURRENT)
- ‘NCF’ Non-Contact Frequency Detection
- Relative reading (Rel)
- Input impedance 10MΩ
- ‘ OL ’ Over range display
- Low battery indication (2.6V approx.)
- Maximum Conductor diameter for measurement (mm) < Ø50
- Maximum open jaw (mm) : Ø50
- Measurable temperature from thermocouple -50°C ~ 1000 °C (-58°F ~1832°F) 
- 'K' type temperature Ni-Cr and Ni-Si sensor, temperature range measurable -40°C ~ 250°C ( -40°F ~ 482°F) to be provided
- Battery powered : 1 x 3V (CR2032)
- Dimension (LxWxD) mm : 208x77x16
- Weight (approx.) grams : 140 (without battery)